Re: roadrunner will not connect to e3000 wireless router
What ISP Service do you have? Cable or DSL? What ISP Modem Mfr. and model # do you have? Is ISP Modem/Service using Dynamic or Static WAN IP addressing? What ISP Modem service link speeds UP and Down...
View ArticleRe: QoS and WMM settings slow internet down when enabled
I had the same issue. With Comcast XFinity 25/5 plan, I was getting 16/5. Essentially it was 8 or 9 MB/s less than actual speeds I get while connected using ethernet. After lot of reading, found out...
View ArticleRe: QoS and WMM settings slow internet down when enabled
3GForces wrote:I had the same issue. With Comcast XFinity 25/5 plan, I was getting 16/5. Essentially it was 8 or 9 MB/s less than actual speeds I get while connected using ethernet. After lot of...
View Articlecisco ea2700
I recently got the cisco connect express and I was able to figure out all my connect devices but one. All it says is unkown device and I can not click on it like the other devices so I can see the mac...
View ArticleRe: cisco ea2700
I got it to disappear from network map by unchecking ipv6 in advance settings but still shows up on cisco connect express
View ArticleRe: cisco ea2700
What Firmware version is currently loaded? Is it up to date?What is this device? What browser are you using?Try Opera or FF? If IE 8, 9, 10 or 11, set compatibility mode and test again.Disable any...
View ArticleRe: cisco ea2700
ID shut off all the devices you have see if it disappears. If not, change WiFi PW and SSID.
View ArticleRe: EA2700 transmits default SSID even though 5Ghz disabled.
I have a E4200v2 and it uses a similar build firmware as yours and for me also for a short preiod after I reboot my router, the 5GHz radio is shown as unsecured and it has the default SSID...
View ArticleRe: WRT1900AC Internet dropping
me too!! updated firmware automatically (didnt know it updated until i had logged on here and then i checked my version number) and no issues..06:29:46 up 8 days, 23:02, load average: 1.66, 1.92, 1.95
View ArticleRe: WRT110 Firmware Upgrade
Hi Your download links to the firmware no longer exist.Can you provide me a new link to downlload firmware version 1.0.02? Regards Wouter
View ArticleRe: WRT1900 looses internet in repeater mode
Did you experience this router behavior when the router was using its Linksys stock firmware? Try and revert to the Linksys firmware then check the connection.
View ArticleRe: E3000 (E1200) configuration for DLNA Client
defluc wrote:This modem is new and I do not want to buy one other new without being sure that it will work.How to explain that Net Scan of Android (see message 9) recognizes my peripheral but that...
View ArticleRe: E4200 v1 firmware 1.0.06 "Back Up Configuration" not working
I also confirm this new problem, which appeared immediately upon upgrade to 1.0.06 from 1.0.04. I'm a UK customer and downloaded from http://support.linksys.com/en-eu/support/routers/E4200/download ....
View ArticleRe: E4200 v1 firmware 1.0.06 "Back Up Configuration" not working
I supposed going back to 1.0.04 fixes this?
View ArticleRe: E4200 v1 firmware 1.0.06 "Back Up Configuration" not working
I've not downgraded yet because I made a backup immediately prior to the upgrade, and will rely on that until I have new changes to backup. That assumes that nothing else broke.
View ArticleRe: E4200 v1 firmware 1.0.06 "Back Up Configuration" not working
Let us know how it goes...
View ArticleRe: EA4500 too slow?
MisterRedShow, have you tried this with WMM disabled? Sometimes, disabling WMM does the trick. Re-enable WMM if disabling it won't work. You may want to consider FurryNutz' suggestion to call Technical...
View Article